New products



Lowther DX65


New product

Lowther DX65 high efficiency fullrange

More details

In Stock

896,00 € tax incl.

More info

The DX series of drive units employ 'state of the art' rare earth magnet technology. The magnet assemblies are extremely light and compact, yet much more powerful than any conventional magnets. Coupled to Lowther's own ‘Hi-Ferric' coil control system, the acceleration and damping factors are increased well beyond anything achieved in the past, even with the extremely large and powerful magnet assemblies for which Lowther has always been renowned. These all-powerful magnet assemblies allow the diaphragms to reach acceleration rates well beyond the capabilities of any conventional magnet system.

The effect of such powerful magnet assemblies coupled to the ‘Hi-Ferric' coil control system, increases the speed of the cones and yet has a truly remarkable degree of damping. This results in an exceptional transient response, but with the oscillating factor reduced to an absolute minimum by the remarkable control of the ‘Hi-Ferric' system.

Using the latest method of construction, the inner cone is now isolated from the outer. This is not readily visible, but what is noticeable is that the rim of the inner cone is terminated with a reverse roll. Where once sound frequencies cancelled each other and information was lost, now all that information is retrieved and can be enjoyed. Where once sound frequencies were reinforced by the two cones working in unison at certain frequencies, now there is no over-forward sound reproduced. The frequency range is so smooth, and so much more detail from the recorded source is reproduced, that an entirely new level of listening experience will be enjoyed.

The amount of information now obtainable from the recorded source is truly remarkable. If it is on the recording then it will be heard. No detail is missed and no degrading of the signal will occur due to unwanted coil oscillations.

It is true to say that never before has it been possible to achieve such a quality of sound reproduction. The DX series achieve a realism to sound reproduction that has to be heard to be believed.

Perhaps the most remarkable feature is the very compact size and light weight and yet with a magnetic power which is more than 10 times that possible from conventional magnets.

The DX series of drive units have so many advantages and this all adds up to a quality of sound reproduction that will provide a level of listening enjoyment equalled only by the pleasure of a live performance.


(1) Suitably housed, multi-unit assemblies do not necessarily require passive cross-over systems between bass, mid and high frequency units.
(2) All units are rated at 100 Watts.

DC Resistance of Voice Coil     Re     7.4 ohms
Free Air Resonance     Fo     82 Hz
Emission Piston Area     Sd     0.01055M²
Equivalent Volume Suspension     Vas     4.267 Ltrs
Suspension Compliance     Cms     269.987 u M/N
Mass of Cone     Mmd     7.0 g
Mass of Moving Parts     Mms     7.623 g
Force Factor     Bl     11.99 T-M
Mechanical Q Factor     Qms     6.109
Electrical Q Factor     Qes     0.266
Total Q Factor     Qts     0.255
Voice Coil Inductance @ 1 kHz     Le     31.813 uH
Reference Efficiency     No     2.117%
Sound Pressure Level     SPL     95.276 Db

Overall diameter         17.4 cm     
Overall Depth         8.60 cm     
Depth from Rear of Mounting Frame        7.8 cm
PCD Mounting Centres        15.6 cm
Baffle hole cut-out         13.7 cm
Magnet Ring Diameter        9 cm
Voice coil diameter         3.9 cm
Voice coil impedance (nominal)         4, 8 or 15 ohm
Air gap width         1.0 mm
Air gap height         5.0 mm
Magnet type         'Hi-Ferric'™ Rare Earth
Flux density (1 Tesla=10,000 gauss)         2.2 Tesla
Diaphragm         Twin-paper
Frequency response         80 Hz - 22.5 kHz
Maximum voice coil travel         ± 1 mm
Shipping weight         3 kg


No customer reviews for the moment.

Write a review

Lowther DX65

Lowther DX65

Lowther DX65 high efficiency fullrange